How to choose the correct size ring to fit properly..

1. Decide on which finger you are going to wear the ring. The fingers on your dominant hand is normally larger than those of the other hand.

2. Cold weather tends to cause your fingers to shrink a bit.

3. High temperatures and other factors like water retention, injuries, etc. can cause swelling of the finger. Measure your finger in warm temperatures at the end of the day.

4. Keep the size of your knuckle in mind.

5. The perfect fit will mean that the ring will feel comfortable most of the time, but not always. Sometimes it might feel a bit loose and sometimes a bit tight - all depending on the weather, what you eat, whether you work with your hands a lot or whether you have some underlying medical conditions. It should fit snug without leaving marks or bulging. or having to use soap or oil to take it off.

• Resin, Ceramic, Carbon Fibre and Metal rings

Correct fit: the ring should slide over the knuckle easily (with just a little bit of friction) to fit snugly, comfortably on the base of the finger. (Not too tight). In removing the ring you should use a little extra force and feel a bit of resistance.

• Silicone rings

If your knuckle is a lot larger than the base of your finger, you need to measure both the base of your finger and your knuckle, then select a size between the two. These rings stretch to pass the knuckle and need to fit snugly, yet comfortably on the base of the finger. No half sizes in silicone, you need to take the smaller size, eg: you need size 10.5 you will take size 10.

METHOD 1: Measuring the Diameter (Inside)

1. Measure a metal ring that you already own and fits properly on the exact same finger as the one for your new ring.

2. Put this ring onto a ruler and measure the inside centre line (diameter) in millimetres.

3. Now find the size for your diameter measurement on the International conversion chart below.

4. If you ordered the incorrect size, a replacement fee will be charged.

• Remember: If you have large knuckles your Resin, Resin Wood, Tungsten wedding band will be sized to fit over that part and will most probably be a little loose around the base of your finger. A silicone ring is flexible and fits snugly around the base of your finger but will stretch to pass the knuckle.

Method 2: Measuring the circumference (outside)

1. Cut a piece of string (preferably not stretchy) or a strip of paper (plus-minus 8mm wide x 120mm in length). Wrap the string/paper very tight around the ring finger.

2. Use pen/pencil to mark the string/paper where it completes the circle and the two ends meet.

3. Lay the marked string/paper flat on a ruler and measure the length of the marked area in millimetres.

4. Use the International conversion chart below to find your corresponding ring size in the circumference table.

5. If you ordered the incorrect size, a replacement fee will be charged.

• Remember: If you have large knuckles your Resin, Resin Wood, Tungsten wedding band will be sized to fit over that part and will most probably be a little loose around the base of your finger. A silicone ring is flexible and fits snugly around the base of your